Key Takeaways
- Volume degrowth, back-half recovery bet: Q1 volumes were substantially low as the MHCV industry heads for a 5–6% FY25 decline, but management expects Q3 and Q4 to do the heavy lifting to reach the ~400,000 vehicle level.
- Product gap is the story, not just the cycle: The company underperformed its largest customer because it lacked the right bus axle; a new launch in Q4 is designed to close that gap and target 30–40% share in the segment over 6–12 months.
- Brakes quietly becoming material: Brakes share of business has grown from 30–35% to ~40%, with a long-term target of 48–50%, supported by a new ICV brake launching next quarter.
- Capex signals confidence in the next peak: A ~₹100 crore+ investment in housing and gear manufacturing is underway, with payback expected in 2–4 years, timed for the next M&HCV peak 3–4 years out.
- What to watch next quarter: Whether the new ICV brake launch lands as planned, any order book visibility for the Q4 bus axle, and whether Q2 volumes show the sequential improvement management needs to hit its full-year industry assumption.
Demand Environment & Volume Outlook
- MHCV industry in a down year: The domestic MHCV market is expected to decline 5–6% in FY25, with Q1 and Q2 bearing most of the pain; Q3 and Q4 are expected to perform better and carry the year to the 400,000 vehicle level.
- Next year looks flat: Management sees the market remaining flat with little change in product mix, implying no rapid cyclical snapback.
- Next peak 3–4 years away: The next M&HCV peak is expected around 3–4 years down the line, driven by the trend toward higher HP and higher tonnage vehicles.
- Off-highway peak sooner: The off-highway market's next peak is expected in 12–18 months, though the company's addressable market is only ~40% (wheeled applications) and some products are still in development.
- Product mix is a vulnerability even on flat volumes: Buses are expected to be in higher demand due to the COVID-era shortfall, and the company's lower share in that segment means mix alone can hurt; the new bus axle is the direct answer.
Nagaraja Gargeshwari: "So probably the next peak will be around 3, 4 years down the line. The reason is, the trend in the market is to higher HP, higher tonnage vehicles..."
Product Launches: Closing the Gaps
- New bus axle (Q4 FY25): A product gap was identified in buses, where the company had lower share of business; the new axle is noise-sensitive, higher-efficiency, and EV-ready, capable of handling central-driver or remote-mount motor configurations.
- Bus axle ramp-up timeline: Launch in Q4, with full potential expected by Q2–Q3 of next fiscal year, probably by Q2; the aspirational target is to reach 30–40% share in that segment over 6–12 months.
- New ICV brake (Q3 FY25): A new brake for the intermediate commercial vehicle segment is in validation and will be ready for launch next quarter, opening an opportunity to increase market share beyond the current position.
- Upgraded tipper/construction axle: An existing product has been upgraded to meet the high HP requirements now popular in the tipper segment; confirmed orders are already in hand.
- Axles above 49 tons and for 9-meter buses: Additional launches planned between Q3 and Q4, as per the time plan.
- Fuel-agnostic design philosophy: New axles are designed to handle CNG, LNG, diesel, petrol or electric duty cycles, so the company's actions are not tied to any single powertrain outcome.
Kishan Kumar: "It's a noise-sensitive axle that we are launching and also with the higher efficiency which is more critical. And our axles are also EV-ready, which means the same mechanical axles can be used in buses where we have a central driver or remote mount configuration of motor and our axles are capable to manage that duty cycle as well."
Brakes Business: The Quiet Growth Engine
- Share of business rising: Brakes has grown from 30–35% of the company's business to close to 40%, with a long-term strategy to reach 45–48% and eventually 48–50%.
- Drum brake dominance: The predominant focus is the drum brake segment, where only two players compete; disc brake volumes in India are very small and expected to remain so for at least the next two years.
- Export opportunity in brakes: The company is pursuing certain export opportunities, though Indian brakes are heavy-duty applications unique to India and different from other regions.
- New ICV brake as the next leg: The upcoming ICV brake launch gives the company presence in a segment where it is currently absent, supporting the share-growth ambition.
Nagaraja Gargeshwari: "And we have a plan to grow it up to 50%, okay. Sometimes it is little bit difficult for us to tell whether it is going to happen in 1 year or 2 years. But our effort is continuously to increase our share of business."
Customer Concentration & Export Structure
- All exports flow through Meritor: Every export sale goes to other Meritor sites globally; the company does not sell directly to non-Meritor or non-group customers beyond the existing UD relationship, and management does not see that changing.
- Export share still modest: Overall exports are close to double digits as a percentage of total business; the company is working on a long-term strategy to improve this, with the scope being to increase content per existing customer rather than add new ones.
- Underperformance vs largest customer explained: The company grew 7.5% while Ashok Leyland grew ~10%, because Leyland did exceptionally well in buses where Automotive Axles had a lower share of business due to its product gap; the new bus axle is designed to fill that gap.
- Cummins powertrain collaboration: The company is working with 1–2 OEMs on a complete powertrain system approach (diesel, transmission, axle), but this is a long, stretched process and may not materialize in the very short term.
Capacity, Capex & Margin Levers
- Capacity utilization running at 65–70%: On average, utilization is 65–70%, with peak months reaching 80–85%; a 5-year strategy is being developed to optimize this and balance investment.
- ~₹100 crore+ capex approved for FY25–26: The board has approved investment in upgrading the housing value stream and gear manufacturing; payback is expected in the medium term, anywhere between 2 to 4 years.
- Sustainable margin math: At 100% capacity, full-year margin could be ~13%; peak utilization of 90–92% would also yield ~13%, suggesting that is the structural ceiling under current conditions.
- Cost reduction initiatives underway: Margin enhancement efforts include product optimization, supplier productivity and efficiency work, lightweighting of parts, manufacturing process enhancement, and yield improvement, though no quantified target or timeline was given.
- Other income elevated for now: Higher other income reflects substantial cash on hand being deployed for maximum return; the run rate depends on whether the company uses internal surplus or borrows for capex, a call expected shortly.
Nagaraja Gargeshwari: "But this is necessary because if we don't invest now, we will not be ready for meeting the peak requirements, which will be coming in the next 3 to 4 years down the road."
Guidance & Commitments
| Commitment | Specifics | Timeline |
|---|---|---|
| New bus axle launch | Product launch to close gap in bus segment; target 30–40% share in that segment | Launch Q4 FY25; full potential by Q2–Q3 next fiscal; 30–40% share over 6–12 months post-launch |
| New ICV brake launch | Product in validation, ready for launch to increase brake market share | Next quarter (Q3 FY25) |
| Axle launches (49 tons, 9-meter buses) | Additional product launches as per time plan | Between Q3 and Q4 FY25 |
| Brakes share of business | Grow from ~40% to 45–48%, eventually 48–50% | Long-term; no specific year given |
| Capex program | ~₹100 crore+ investment in housing value stream and gear manufacturing | FY25–26; payback in 2–4 years |
| Next M&HCV peak | Industry peak expected; company investing now to be ready | 3–4 years down the line |
| Off-highway peak | Next peak in addressable wheeled applications (~40% of market) | 12–18 months |
| MHCV industry FY25 | Industry expected 5–6% down; Q3 and Q4 to do the heavy lifting | FY25 full year |
Key Metrics
| Metric | Q1 FY25 |
|---|---|
| Revenue | Declined ~1% YoY, driven by volume degrowth; commodity price impact minimal |
| Revenue growth vs major customer | Grew 7.5% YoY, compared to Ashok Leyland's ~10% YoY growth |
| MHCV industry volume outlook (FY25) | 5% to 6% decline expected for the full year |
| MHCV industry volume (FY24) | ~425,000 vehicles |
| MHCV industry volume outlook (FY25) | ~400,000 vehicles expected |
| Capacity utilization | 68% to 70% on average; peak months reach 80% to 85% |
| Peak capacity utilization (time-tested) | 90% to 92% |
| Sustainable margin at 100% capacity | ~13% for the full year |
| Brakes share of total volume | ~10% to 15% |
| Brakes market share | 37% to 38% currently; long-term target 48% to 50% |
| Brakes share of business | ~40%, up from ~30% to 35% a few years ago; plan to grow to 50% |
| Exports growth | Sustained at same level as compared to last year |
| Export geographic mix | 40% North America, ~30% Europe, ~10% Australia, plus South America and China |
| Capex plan (FY25 and FY26) | ~₹100 crores plus, Board-approved; for upgrading housing value stream and gear manufacturing |
| New bus segment tender pipeline | INR1,500 to INR2,500 crores current visibility |
| New bus product market share target | 30% to 40% in the new segment |
| New bus product share of business target | 20% to 30% aspirational target over 6 to 12 months post-launch |
| M&HCV next peak expectation | 3 to 4 years down the line |
| Trucking load-carrying capacity | 8.7 trillion capacity at a 400,000 vehicle level market |
| Investment payback period | 2 to 4 years medium-term |